|
HOW TO SHOOT
L-SERIES™ TARGETS
Newbold's (Auto-Reset) L-Series™
Targets — can be mounted on a soft
wood surface, such as pine-board 2X4s, 2X3s or 1X6s... so they’ll snap backwards with each
hit (even double-taps) and then auto-reset back to the upright position. One-piece
L-Series targets feature a flexible hinge at the base (made of the same ElastiMAX™ material as the target). They
don’t bend all the way back to a horizontal position. For example: The target
moves, flexing backwards when hit with .22 Long-Rifle high-velocity rounds, but moves more
with a .38 and still more with .45 caliber rounds. The best thing about
the L-Series is that there is no need to go down-range to reset this target.
Use Newbold’s ElastiMAX™ (Self-Sealing) Nuts & Bolts —
Secure your L-Series targets to soft wood surfaces with
these self-sealing nuts and bolts. Two ElastiMAX™ bolts with nuts are required per
target. When mounting them on the wood stand, drill two 9/16" holes per target.
Place the ElastiMAX bolts through the target base and into the holes.
Push the nut up onto the tip of the bolt and then tighten the nuts just enough to leave
them a little loose. When they are a little loose, the target will flip back and
forth more with each hit.
Use Newbold’s ElastiMAX™
Support Bases — for larger Round targets,
Square targets and Bowling Pin target shooting, where the idea is to "Knock ‘em
down so they Stay Down," L-Series™ targets "snap-on" to these support bases easily. When
they’re shot with a solid hit, the target, along with the attached support base,
falls over or falls completely off a post or stand. These Support Bases (made of the
same material as the targets) also help to steady any L-Series™ Target on an uneven surface and provide more stability for the targets when
you're shooting outdoors in windy conditions.
To Order These Targets:
|
|
