Want to become a Newbold VIP?
Become a Newbold VIP Today!
Newbold's 6" BounceBack Series Plate Rack Kit includes (6) 6" BounceBack Targets in Orange, (6) BounceBack Support Bases and (1) Set of our Alpha Stand Brackets and requires little assembly. All you have to do is add standard 2x4's to build a complete plate rack that is light weight, indoor and all-weather safe for use both at the indoor range or to be kept outside in any weather condition.
Newbold’s 6" BounceBack Series Target mounts on soft wood 2X4s. With each hit the 6" BounceBack Series snaps back and then bounces back to the upright position. There is no need to go down-range to reset this target. The one-piece 6" BounceBack Series target has a flexible hinge at the base made of Throom™, the same polymer material as the target, so bullets pass throo the target and the hinge. For an entirely different reaction, remove the bolts to knock the 6" BounceBack Series Target completely off the stand.
Newbold’s Alpha Stand is an innovative set of target stand brackets that can be assembled in under a minute and are shoot through safe and ricochet free. These light weight brackets require no metal fasteners or hardware and make it simple and easy to transport your target stand to and from the range. Compatible with just about any length 2x4s (lumber sold separately) the Alpha Stand can be assembled any length from 2’ – 8’ long with two brackets and as long at 16’ with a third bracket. This fully customizable stand is super strong and ultra-durable so it can take the hits just like our Newbold Targets. If the Alpha Stand is hit the bullet will pass through the material leaving minimal damage and will not bounce back to the firing line as seen with other steel target stand brackets. At 2 ½ lbs each the Alpha Stand is the safest, most light weight and durable target stand on the market.
Must purchase 2x4s separately to assemble target stand. One 3’ tall x 8’ long Newbold Alpha Stand requires (3) 2x4x8s. (1) eight-foot 2x4 for a crossbeam and (2) eight-foot 2x4s cut in half to make (4) legs for the stand. Once assembled you may mount your BounceBack Series Support Bases to the stand using (4) wood screws and snap the 6" BounceBack Series Plates into their Bases or you can just stand the targets and bases up on the stand and knock 'em over!